Bee-R limiter on carb'd 13b
 

so i have a S4 13b peripheral port in my AE86 corolla. my ignition set up is as follows:

Leading:
2x MSD 6a boxes connected to 2x msd coils and the signal is from the leading magnetic pick up on the distributor

Trailing:
Factory ignitor wired to one msd coil and then ran through the distributor.

i will have a Bee-R limiter very soon and i need to know how to wire it. from the translations ive found on the web so far i found the wiring is as follows:
Red wire: 12V+
Black wire: ground
yellow wire: RPM signal
green wire: ignition signal
and to cut the looped brown wire for rotary engines

now my problem is, everything i have found explaining how to wire this up shows wiring to the ECU. i do not have one so i need a little help to figure out how to run the yellow rpm signal wire.

my main issue is that i do not know how the limiter sends the signal to cut ignition. is it all from the yellow wire? if i wire it to receive signal from the trailing coil, like the tach, would it then only try to cut the trailing coil?


HALP!

While i don't know how to do it, listing what standalone you have might be able help whoever has knowledge on how to wire it up. Good luck with it!

i have no ECU or CPU. its just the msd boxes and coils. on a carbd p port.
Attachment 724964

i was running one 6AL, but running the two coils off of it blew it.

From what i would expect, the ignition signal is cut.
So that would mean you have to splice it into the wiring, in series between the pickup and MSD, allowing it to cut the signal.

However, i never owned a bee-r, nor a carbed rotary so i could be way off

Nice, an ae86 with some long lasting POWER!! Toyota A series engines = NOODLE BLOCKS!

The force is strong w/this one!!

I HAD an ae71 coupe...t3 front suspension, and I repainted it 8N6 (i think that was the code...) Lexus "Bluestone Grey effect", put lexan in ALL 5 rear windows (2 quarter windows each side) and yes lexan/polycarbonate IS more than 50% lighter than glass of equal thickness! That was a descent into madness on my part....IDK WTF I was thinking!!

I shouldn't have wasted all that time & $$$$! But that's my opinion.

-Sorry, I can't help u w/the Bee-R, good luck tho!! Can't wait to see some vids of u getn silly sideways w/it!!