counter wieght
do i use a puller to get counter wieght off 13 b with auto trans:"?on rear of crank..and what kind>>>?any other sug.?....10mm
|
does it have threaded holes in it? if so find some long bolts that thread threw, put 2 across from eachother and tighten them down with a wrench, a bit at a time then switch sides, and it should pull it off, cant remember if i did this with the front or back counterweight tho so it may be of no use to you, if it doesnt have holes, nice heavy rubber mallet and a pry bar with a wrag on it
|
+ one on rubber mallet.
I JUST did this 12 hours ago on Jordans 5 speed swap |
iv hit it 100 times after got big nut and little bolts off,, im takin to work to let machainic do.. ill lets u nn ,,thx :}
|
um i think u just get the right suze socket and like beat it off im not sure ill has the person who did it and see wat they say
|
rear counter weight is a bitch, mazdatrix.com sells the puller..not sure how much it is though. you might try heating it, that is if you have access to a cutting tourch and all. good luck
|
rubber mallet ftw
|
PB blaster! and a rubber mallet! LOL
|
LMAO I have a new sig as well grae
|
leave the flex plate on and then hit that with a rubber mallot.
|
ok thanks ill try all those ideas , and let u no:}
|
Originally Posted by Boost Lee
(Post 9226287)
leave the flex plate on and then hit that with a rubber mallot.
Scare it off? :dunno: |
we did it , used a reg. puller .though bolt holes ,tighten her up,and hit with rubber mallet,topped right off.thank you guys ,,:}
|
BFH works every time FTMFW
|
The US military has a manually-operated-impact-device for which we tax payers pay $700.00.
We can go to the local hardware store and buy the same manually-operated-impact-device for $7.00, but we call it a hammer. |
All times are GMT -5. The time now is 09:09 PM. |
© 2024 MH Sub I, LLC dba Internet Brands