Description:

This includes everything to swap the CD009,350z or 370z transmission with concentric slave into an FC RX7 or be utilized on ANY 13B engine.

This is the careless kit that was for sale on RX7Club.com. This kit was developed on my car by the seller of the original kit.

If you're using this kit on an FC RX7 you will only be required to complete the following:
1. Purchase a transmission
2. Create a transmission mount
3. Fit the transmission in your tunnel
4. Purchase an automatic rear counterweight to accept the fly wheel.
5. Adjust the hydraulic line at your clutch master to meet up with the line from the concentric slave.

If you're using this kit on another chassis running a 13b engine you will be required to complete the following.
1. Purchase a custom driveshaft
2. Purchase a transmission
3. Create a transmission mount
4. Purchase an automatic rear counterweight to accept the fly wheel.
5. Fit the transmission in your tunnel
6. Adjust the hydraulic line at your clutch master to meet up with the line from the concentric slave.

Price is $2900USD Shipped obo.
I will not split the kit up, it will be sold complete. For those that do not require the driveshaft I will exclude only this item for a reasonable offer. Please do not bring up 2018 pricing for the original kit which did not include the clutch, flywheel, clutch lines, modified bell housing, modified starter or driveshaft. Keep in mind this kit is no longer available and if it was available the price wouldn’t be the price from 2018.

Items provided in sale:
1. Does not include the transmission. I will include the modified bell housing from my transmission to save you time on install.
2. Starter mount that uses the FC starter
3. FC modified starter included.
4. Adapter plate c/w all fasteners for both transmission to adapter plate and adapter plate to 13b engine.
5. Very lightly used Bully single disc clutch, 4puck sprung clutch. The clutch was just refreshed in September by Bully and only has 2 laps on it. The clutch is rated for 500ftlbs of torque. We are making 455ftlbs with my setup and it does a great job.
6. Fidanza aluminum flywheel with very lightly used friction surface. The friction surface was replaced in September and only has 2 laps on it.
7. Concentric slave c/w mounting, fasteners and lines.
8. Fly wheel spacer that came with the original kit c/w ARP fly wheel bolts. Bolts were just replaced.
9. Shaft masters aluminum driveshaft for use in FC RX7 with turbo II differential.

PLEASE NOTE YOU NEED THIS CLUTCH IN ORDER TO MAKE THE KIT WORK DUE TO THE NISSAN SPLINE ON THE TRANSMISSION. YOU CANNOT USE YOUR FACTORY CLUTCH. IF YOU’RE USING THIS IN AN FD RX7 YOU CANNOT USE YOUR FACTORY PRESSURE PLATE, THE FD IS A PULL TYPE CLUTCH, THE CONCENTRIC SLAVE IS A PUSH TYPE. AGAIN YOU REQUIRE THIS CLUTCH ASSEMBLY.

Andrew.