RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   New Member RX-7 Technical (https://www.rx7club.com/new-member-rx-7-technical-256/)
-   -   new rx owner...i need help (https://www.rx7club.com/new-member-rx-7-technical-256/new-rx-owner-i-need-help-1016736/)

swissmiss-ter 11-03-12 10:22 PM

new rx owner...i need help
 
2 Attachment(s)
ok so i got an 86 rx7 n/a 5 speed a few weeks ago, and have been working on getting it back on the road (bought it non running). well i got it running and driving, but i am having a few problems; mainly: gauge lights dont illuminate, and the idle drops when it gets warmed up and it will then stall out. there are some wires that i noticed are disconnected, and im trying to figure out where they go; maybe they are causing some of my problems. in any case, i want to figure them out to hook them back up. so if anyone can help me out, that would be great. here are some pics to illustrate.

as you can see, its the black connector next to the thermostat housing
Attachment 692453

this wire harness/group of wires was dangling underneath the car(i just pulled them up through the engine bay). from my understanding, the black and green wires hook up to the fifth gear switch on the transmission, and the wires on the end(not pictured) are for the reverse lights. but i dont know where these two connectors go. it looks like the wires were pulled out of the back of them.
Attachment 692454

Xcom90 11-05-12 07:57 AM

i can tell you that our idle dropping issue you might want to check your iac. make sure your getting proper volts to it. i thnk it should be getting a 5 v reference

swissmiss-ter 11-05-12 05:38 PM

ok. ill check that out. but still would be great if someone could help me out with these wires...

iDanglePistons 11-06-12 12:40 PM

Loose wires are usually a result of a swap or repair where engine may have been pulled. In many cases people just want the car to RUN and disregard any wires that don't affect the engine mechanically. At least that's the case with 240s. I could be wrong here though.

swissmiss-ter 11-06-12 04:41 PM

i dont think its a motor swap. it looks like the ends of the first wires were melted and then pulled apart. the transmission may have been swapped, because thats where the second wires were going to, and that whole group of wires is disconnected (5th gear switch, reverse lights, and whatever those other two connectors are for). i really just need someone with an FC to look at those particular wires and see where they go for me..

swissmiss-ter 11-08-12 04:26 PM

anyone? help a brotha out!

rodiviousx7 11-15-12 07:47 PM

first picture looks like the nuetral switch but i could be wrong


All times are GMT -5. The time now is 04:06 AM.


© 2024 MH Sub I, LLC dba Internet Brands