help thanks
 

was thinking bought new carb holly or Weber what you guys think?

was thinking..can you be more vague???
engine?,was it carbed before?.Mods?
specific carbs in mind,as in Part number?

yes

It depends on whether round fish plot is a winning kangaroo coach.

https://www.rx7club.com/customprofil...ic173636_2.gifsory i just this car and its a 12a it has a holly carb on it now and i keep flooding it i too out all the pugs and turned over the car and it all most started it has raceing beat header was thinking maybe new carb

Maybe if you take the pugs out and clean them it will purr like a Kitten?...
SORRY Man!,I had too!..it was so cute!

Have you taken a tour by the 1st gen Specific section yet and looked at some setups there and compared anything?

my head is still spinning as to what the question is here. you already have a holley but you have STARTING ISSUES. so the question now i assume is why the car won't start.. in which case there is the 3 basics: fuel, ignition and compression.

spray carb cleaner in the intake and try to start it, if it does then your ignition and compression should be ok. test ignition with a timing light while cranking the engine, and compression by searching the proper method of testing it. if the other 2 come out fine then your carb may be crapped up and need to be serviced, or pump took a dump from sitting, or gas in the tank rotten, etc, etc, etc.

if you just rebuilt the engine start with a compression test or pull start it. reusing marginal or severly worn components will result in difficult starts for quite some time.

sory at first was trying to get input on both carbs maybe go from there the car did start ran for 10 sec and then stalled after i cleaned the plugs but i think trying to keep it running may have flooded it agen

clean the plugs again and hold the idle up until you can get an idea if it will idle on its own.

Webber carb any day for me.
Easy to tune and jets are easily accessible with the wing nut