FC Injector Fitment
Quick question, I'm about to buy new injectors for my build from RC and am not sure which style and impedance the FC TII used. I tried searching but found a few competing answers. So I'm planning on running 750cc primaries and 1200cc secondaries. I need to know if I need P&H injectors or saturated, also bosch or denso style. Any help would be much appreciated. Thanks.
|
Your question is specific about the impedance of the injectors you need? S4 Early is Low Impedance (with a resistor pack), S4 Late is High Impedance, S5 is High Impedance.
Take a multimeter to your current injectors and measure impedance between the terminals. 8 ohms or less is low impedance, over 10 ohms is high impedance. Stock TII injectors are 550cc. |
[QUOTE=BTNH-LC;12331604]Quick question, I'm about to buy new injectors for my build from RC and am not sure which style and impedance the FC TII used. I tried searching but found a few competing answers. So I'm planning on running 750cc primaries and 1200cc secondaries. I need to know if I need P&H injectors or saturated, also bosch or denso style. Any help would be much appreciated. Thanks.[/QUOTE
You will need Denso style tops in peak and hold. As far as high or low impedance if you're running a standalone it need not apply, if not the member above me that commented is spot on. I run a similar setup fuel wise the only difference being 1000cc secondaries, which should net around 350whp(I don't specifically recall the exact number from when I did the fuel calculations). |
Cool, I just ordered RC peak and hold injectors. Thanks for the help guys.
|
All times are GMT -5. The time now is 05:57 PM. |
© 2024 MH Sub I, LLC dba Internet Brands