safe boost?
Should I use the boost cutoff function on the microtech ls8 to help with overboosting untill I get my electronic boost controller. Ive got it set for 10psi currently. I am thinking that the next bit of money should get to a ebc so I can set it for 5 psi until I can get the 1600cc injectors installed in a new secondary rail. I figured then I would get a wideband to make sure I dont go lean and finally the 1600cc injectors last. Is my thinking off. Other thoughts were to not get into any boost until I can save up for the secondary rail then get the ebc and wideband. Any settings I can use on the microtech other than boost cut to make sure I dont lean out and blow the motor until I can get the 1000 or so for all of it?
|
Get teh 1600cc injectors and rail first.
Then get wideband. then boost controller. the boost cut. If your running 10psi. Set the boost cut at around 16psi. |
would getting 1300cc for now be enough for my turbo or should i wait until i can get the rail for the 1600's and the fpr.
|
1300CC injectors + FPR will do the trick.
|
All times are GMT -5. The time now is 02:50 PM. |
© 2024 MH Sub I, LLC dba Internet Brands