LT10C fuel pressure sensor
Thread Starter
Full Member
Joined: Feb 2018
Posts: 52
Likes: 0
From: Puerto Rico
LT10C fuel pressure sensor
So I want read/datalog fuel pressure from the micro is there anyway to conect a 0-5V fuel pressure sensor to the ecu? Anything besides buying the fuel/oil pressure kit from themselves? Thanks
onrxtc
Joined: Mar 2007
Posts: 14
Likes: 1
From: Brisbane, Australia
Yes, you can. There's an addition 6 pin connector on the LT10C ECU which allows for oil and fuel pressure sensor inputs (see their website for wiring reference).
I've used cheap generic 150 PSI eBay sensors and they work fine. Make sure the LT10C set to either 150 or 250 PSI setting in its configuration depending on which sensor you go with.
I've used cheap generic 150 PSI eBay sensors and they work fine. Make sure the LT10C set to either 150 or 250 PSI setting in its configuration depending on which sensor you go with.
Yes, you can. There's an addition 6 pin connector on the LT10C ECU which allows for oil and fuel pressure sensor inputs (see their website for wiring reference).
I've used cheap generic 150 PSI eBay sensors and they work fine. Make sure the LT10C set to either 150 or 250 PSI setting in its configuration depending on which sensor you go with.
I've used cheap generic 150 PSI eBay sensors and they work fine. Make sure the LT10C set to either 150 or 250 PSI setting in its configuration depending on which sensor you go with.
Newbie
Joined: Feb 2019
Posts: 3
Likes: 0
From: Sydney
hey guys, hope you guys are still around to help.
I just picked up some microtech sensors my mate had laying around with the wiring. But i'm abit confused.....
There are six wires all up, but 2 seem to be can hi and can low, so there is 4 wires left but each sensor need 3 wires?
If anyone knows what wire is what the help would be appreciated.
blue wire?
white wire?
grey wire?
black wire?
cheers
I just picked up some microtech sensors my mate had laying around with the wiring. But i'm abit confused.....
There are six wires all up, but 2 seem to be can hi and can low, so there is 4 wires left but each sensor need 3 wires?
If anyone knows what wire is what the help would be appreciated.
blue wire?
white wire?
grey wire?
black wire?
cheers
Thread
Thread Starter
Forum
Replies
Last Post