Error Check - I have a few questions
 

I decided to smooth out my Idle Maps today. With good success I shut my car off to cool down. A short while later I started It up again to find out I had Errors on both Error Check screen 1 & 2.

Under screen 1 ~ Error - Ref
Under screen 2 ~ Error - RPM

I do believe this was talked about before (I'm not sure to what extent). I've searched but couldn't find what I was looking for. What are these Errors? What may have caused them and how do you corect these?

I used to get rpm errors every so often, but only when the car had died from the electrical load. since i've richened up my idle map i havent seen it again. I got the REF error once too but i have no idea what from. Sorry, i'd like to know as well.

Okay, It gets stranger now...

B'c I was abit mistified on these errors, I went out again to see If I missed or overlooked something...well I'll be damned! It was gone. :confused:

Is there an explanation for this? What Is Error - Ref & RPM mean?

RPM error is a botched signal from the CAS, typically caused by the wiring for the signal pickup picking up (pun!) eletrical interference.

Ref...dunno right now, it's still early in the AM ;)

Try to route your CAS shielded wire away from the alternator wires and pretty much every other wire.

A clear definition on these would be an asset.

Under screen 1 ~ Error - Ref
Under screen 2 ~ Error - RPM