Originally Posted by wankelbug
(Post 11107337)
hey guys im adding ls2 coild to my 13b powered bug. i am currently using the stock fc setup. but my coil died so i decided to upgrade. i need someone with experience to answer a couple questions.
here is what i got so far. all coils wired per the diagram on mega manual. including the 2 capacitors. now on the computer side the way i understand is is front rotor leading signal output A d14 with 4.7 pullup front and rear trailing (firing as a wasted spark) are outputs b and c to 2 coils signal wires rear rotor leading output D (js11) then i run it in fd mode with a dwell of 5.5 and set to "going low" correct? im also not running the stock rx7 tach so i can now just grab a signal from an injector wire correct? or should i go into the megasquirt and wire my tach in there? thanks Andrew |
thanks for the reply. i didnt mean to post that here i started a new thread. and was albe to figure it out about 80% so far
https://www.rx7club.com/megasquirt-forum-153/ms2-ls2-coils-1000047/ |
All times are GMT -5. The time now is 04:08 AM. |
© 2024 MH Sub I, LLC dba Internet Brands