Description:

Aquamist 2d water injection system. All parts included from original 2d system plus anti-surge accumulator and flow sensor (the latter two $100+ each by themselves) and a few additional parts.

Everything looks close to new. I ran this for a few thousand miles.

Incredibly high-quality components (2d system alone was $800+ back in the day). You will need to know what you are doing when installing this. 

2d system parts:

Magnetic piston pump (race version)                     1        806-052
FiA2 Fuel injection amplifier Kit                              1        806-441
Stainless High Speed Valve                                   1        806-244
Inline 100 micron stainless filter                             1        806-257
Water pump loom with 15A inline fuse (std.pump) 1        806 286
M6 x 16mm Stainless nut, bolt and washer            1        set of 4
M8x0.75mm tap for water jet                                  1        806-284
40A Power Relay for independent switching          1        806-276
Single channel WI manifold                                    1        806-201
3-30psi Adjustable Pressure switch bracket           1        806-157

0.7mm/0.8mm/0.9mm jets

Additional items:

Flow sensor                                                                 806-428
Anti-surge accumulator                                               806-410
Reservoir level sensor                                                 806-281
Inline #130 micron filter                                               806-259
In-tank #112 micron filter                                             806-270
Analog water pressure gauge

See: http://www.rotorsportsracing.com/per...njection2d.htm