FS - RC Big Bore Throttle Body
For SaleEngine - Intake/Fuel
Feb 3, 2021, 03:32 PM | Replies: 5 | Views: 1504
-
Price
$495
- Location Nokesville, VA, 20181, USA
- Condition Used
- Compatibility
| Make | Model | Year |
|---|---|---|
| Mazda | RX-7 | 1992 - 2002 |
Description:
I updated my ECU and I'll be converting to a DBW Throttlebody to complement it.
As a result, my throttlebody is up for sale. This TB has been modified by RC Fuel Injection to flow more CFM while retaining a smooth idle. The secondary intake ports measure 54mm each, with the primary being 45mm. Both secondary butterflies were replaced by RC in the process. The throttlebody comes with a new o-ring and all parts as shown.
Asking price is $495 plus shipping.
Last edited by fendamonky; Feb 3, 2021 at 03:43 PM.
Reply
Any idea how much more this thing flows versus the stock unit?
Thread Starter
Joined: Sep 2006
Posts: 3,942
Likes: 323
From: Nokesville, Va
I made ~ 480whp with a precision 6265 on this TB and it didn't bat an eye.
Thread Starter
Joined: Sep 2006
Posts: 3,942
Likes: 323
From: Nokesville, Va
I had this service done through rotorsport racing back in the day, he subcontracts the TB to RC Injectors. When I ordered it I also sent my UIM and LIM in for extrude honing, teflon coating (interior) and ceramic coating (exterior).
I dug around a bit more and it seems that folks see the best gains when pairing a bored out TB with flow increases in the LIM/UIM as well. I'm seriously on the fence about just ordering one of the new cast UIMs from Turblown, if I do then I'll likely take this down and sell my extrude honed UIM as a package deal with this TB.
I dug around a bit more and it seems that folks see the best gains when pairing a bored out TB with flow increases in the LIM/UIM as well. I'm seriously on the fence about just ordering one of the new cast UIMs from Turblown, if I do then I'll likely take this down and sell my extrude honed UIM as a package deal with this TB.
