Description:

Racing Beat's fully assembled Stainless Steel Oil Cooler Hose Sets for the 1986-1992 RX-7 TURBO II and Non-Turbo chassis replace the original factory RX-7 oil cooler hoses. Significantly less costly than the Mazda replacement RX-7 oil lines, the Racing Beat-designed RX-7 oil hose sets will easily meet the demands of street and most race applications.

Produced from Earl's Perform-O-Flex stainless steel braid-protected synthetic rubber hose and featuring an inner liner of synthetic rubber, including partial cover of stainless steel braid embedded into the liner during manufacturing. The hose liner is then bonded to a outer protective sheath of stainless steel wire braid. Precision-machined aluminum Swivel-Seal hose ends ensure a secure and superior seal. Each oil line set is carefully assembled and tested by Racing Beat to ensure top-notch quality, reliability and performance. All 86-92 RX-7 oil cooler line sets are supplied with a external anti-chaffe sleeve material to prevent surface wear to the stainless braided-hose during normal operation.

Racing Beat's RX-7 oil line sets are a direct replacement for the original factory lines - no cutting or refitting is required! Select from the adapter fittings listed below to correctly install your oil hoses onto your chassis.

Required Adapter Fittings:
1986-92 13B engines -
Part No. 11901 (1 required)
Part No. 11902 (1 required)

***I will include the two used copper crush washers (pointed out in pic 3). You can use them for reference when you go to buy new ones. These should not be reused!!!***