New Guy
Thread Starter
Joined: Feb 2008
Posts: 509
Likes: 0
From: San Antonio, TX
New Guy
Howdy,
Figured now that I have an RX-7 and ive been registered since last year I might as well post up and get to talkin. So here it is. Just bought her yesterday and got the title and insurance all done today.
1984 Mazda RX-7 GSL-SE
Trans Rebuild Kit
Pilot Bearing
Window Weather Stripping
Patch Exhaust
Fuel Level Gauge [dash gauge doesn't work but sender is still good]Purchased
Stainless Braided Clutch Line
Figured now that I have an RX-7 and ive been registered since last year I might as well post up and get to talkin. So here it is. Just bought her yesterday and got the title and insurance all done today.
1984 Mazda RX-7 GSL-SE
202,5XX miles
Used 13B from Rotary Dave put in at 176,XXX
Dellorto 48 DLHA Carb
Racing Beat Upper Intake Manifold
Leaking Exhaust with "BOMZ" Muffler
Racing Beat Front Sway Bar
Tokico Blue Rear Shocks
Unkown rims from Japan
BFG G-Force Tires
Oil Pressure Gauge
Fuel Pressure Gauge [not hooked up yet]
A/F Gauge
Grant RS Steering wheel
Stripped Interior behind front seats
PlansUsed 13B from Rotary Dave put in at 176,XXX
Dellorto 48 DLHA Carb
Racing Beat Upper Intake Manifold
Leaking Exhaust with "BOMZ" Muffler
Racing Beat Front Sway Bar
Tokico Blue Rear Shocks
Unkown rims from Japan
BFG G-Force Tires
Oil Pressure Gauge
Fuel Pressure Gauge [not hooked up yet]
A/F Gauge
Grant RS Steering wheel
Stripped Interior behind front seats
Trans Rebuild Kit
Pilot Bearing
Window Weather Stripping
Patch Exhaust
Fuel Level Gauge [dash gauge doesn't work but sender is still good]
Stainless Braided Clutch Line
Thread Starter
Joined: Feb 2008
Posts: 509
Likes: 0
From: San Antonio, TX
Thanks 
Ive had a blast so far driving and gettin used to the car. Gonna get some general maintinence done and get some other stuff done then start makin it look pretty.
Some pics after I got the windows and rims cleaned up, the rims are gonna need a good sand blast and repaint as the enamel or whatever kind of plastic clearcoat was on em is now chipping and peeling off.
Ive had a blast so far driving and gettin used to the car. Gonna get some general maintinence done and get some other stuff done then start makin it look pretty.Some pics after I got the windows and rims cleaned up, the rims are gonna need a good sand blast and repaint as the enamel or whatever kind of plastic clearcoat was on em is now chipping and peeling off.
Thread
Thread Starter
Forum
Replies
Last Post
Kruel13
1st Generation Specific (1979-1985)
24
Sep 16, 2015 09:08 AM