Hi from Australia
 

G'day! Thought I'd post up as I've been reading this forum for a while after obtaining an FD. Have been a long time rotary enthusiast, owning a RX-2, Series 2 RX7 an now a 99' FD import from Japan.
Will post up a build thread for my FD, encompassing the current setup and future plans.

https://cimg3.ibsrv.net/gimg/www.rx7...8c41557468.jpg
https://cimg8.ibsrv.net/gimg/www.rx7...9c34355be2.jpg
Stay brappin'

How come I am not able to post in the build threads section, do I need a certain number of posts?

A few more specs on the car:

Feed intercooler kit and inlet snout.
Trust TD07-S turbo and exhaust manifold, trust 48mm wastegate, trust BOV
Rebuilt motor by RMS here in Queensland
Extend port, new 2mm race apex seals, engine doweled.
Haltech P1000 ECU, 1000cc secondary injectors, intank fuelwerks pump upgrade. Microtech x4 ignition drivers. 340whp on 10psi boost.
Twin plate clutch, OS giken upgraded gearbox gearset.
Recently put a set of Work M1 3peice rims, 18x9, 18 x10.
Plans for the future,...OS giken 1.5 LSD, dual oil cooler upgrade, bunch of gauges, an a few exterior body mods.

Welcome to forum from another Aussie Nice rx you have there

Cheers mate, whereabouts in Australia are you? Any particular RX you have?

I am in Melbourne . I have 2 RX's a series 2 with 12a turbo and a series 3 Hurricane with a 20B in it .There is photos of them in my albums

Welcome!

Welcome...

The welds on the IC pipes, especially the hot side look fantastic! is the piping from FEED as well?

Cheers,
The hot side is custom made, the cold side is part of the feed kit
I'm thinking of installing a vmount kit later on, with better cold air induction feeding the turbo inlet.