Thumbs up for F1spec customer service. They called me today to confirm my credit card because it didn't match up. Of course as long as they get their money, what do they care, right? But I still think it was good of them to make sure I wasn't getting ripped off, or ripping someone off.

Also, at the same time they gave me an estimate of 4 business days to Ohio. So hopefully on Tuesday, halloween, I'll be installing a seat before I go out Trick-or-Treating.

Ttt

Waiting for pm reply........

repied to

i got a seat from them, type 2.

was able to use the provided slides and mounts in an FB driver side. had to change up the mounting a bit, some drilling required but really no big deal at all.

seat has very nice lateral and shoulder support, also the back is in the natural driving position.

padding is a little on the thin side, so make sure you take everything out of your pockets if you plan on doing any brisk driving ;)

I have to do that with the stock seats anyway :p

Pics?

i didnt take pics during the mounting, i can describe it though. for the rear i used a nut/bolt through the top of the stock mount. for the front i used a 2 1/2" bolt and went all the way through the floor with a bolt and washer underneath.

i will get some pics of it in the car tomorrow.

and here are pics..i cant get any good ones, theres a jeep parked 4 inches away from my door :(

it took me around 15 mins and a trip to ace to get it to fit very nicely in a 1st gen.

http://memimage.cardomain.net/member...08_71_full.jpg
http://memimage.cardomain.net/member...08_72_full.jpg

I, too will have my installation pics very shortly.

Although I'm waiting on an email response on order yhst-76493336636070-537 from f1spec.com on missing sidemounts/sliders

Got a response. Now I just have to wait for them in the mail.

pm me a price for the Type 3 in carbon and one in fiberglass

Ttt

whos wants these seats =D

seats
 

how much interested

Why? Are you giving them away? I'll take 2 of the type 3 in carbon. I got your pm and will get in contact with you after I get the money togeather.

I'll consider getting a Type 3 in fiberglass (don't have the money to spend on CF or carbon-kevlar, as much as I'd like them) once I have that kind of money to spend (in a few weeks)... assuming I can fix my other problems first.

I figure I could use your side mounts, combined with Wedge Engineering brackets, and Sparco sliders... if that combo would actually be lower than stock at least.

can you pm me with price for a type 3 in fiberglass

Link to my review and installation.

https://www.rx7club.com/interior-exterior-audio-26/installation-f1spec-racing-bucket-595368/

can i get a price check on type 2 in fiberglass and if possible picked up?

ttt

im looking at either the type 1 or type 2 in fiberglass. if possible can i pick up?

Once i see some one install them in to a FD. Then i will be willing to buy but untill then my money stays in my pocket. I hope they fit in a FD because i like them. However, like them as i may but if they dont fit they are useless. :)

anyone wanna test these seats out in a fd?

I will. But I'm in Pittsburgh, PA.