Haltech Setting up E6X boost wastegate controller
Setting up E6X boost wastegate controller
So, I am running a boost controller with my E6X. I know many people have issues/complaints with this simple boost control. Please do not post complaints on this thread! All of the threads on this are difficult to follow because of all of the opinions...
I would like some help tuning this funtion to the best of it's ability. Below is my setup, notice it's not the boost leak method. On my first runs it worked great at holding at 10 psi, see data log in zip folder. Right after I logged I hit 15 + psi leaving from a stop light. I know this is becuase of my duty cycle, but I do not know a good place to start. My settings are in my tune which is attached below in the zip folder. Any tuning tips, or suggestions would be helpful.
I would like some help tuning this funtion to the best of it's ability. Below is my setup, notice it's not the boost leak method. On my first runs it worked great at holding at 10 psi, see data log in zip folder. Right after I logged I hit 15 + psi leaving from a stop light. I know this is becuase of my duty cycle, but I do not know a good place to start. My settings are in my tune which is attached below in the zip folder. Any tuning tips, or suggestions would be helpful.
