Haltech PS2000, latest firmware, CAN protocol set to Version2 in ECU Manager

connecting to Haltech IQ3 Logger dash (shows FW 19, tag on the back 1G12-2)

Datalink version 3.8.6

IQ3 connected on COM3, thru serial / USB adapter

following guide from http://haltech.com/wp-content/upload...gger_Guide.pdf

When trying to write to Vnet config downloaded from Haltech website, getting this error :

Programming device named : EFI Engine RPM
_CONNECT4_COMMAND:
32832 : 8040 5c a1 07 00

CCP ERRROR !!!
Internal timeout

Whent trying to read vnet config it stops after REBOOT COMMAND:
DISCONNECT COMMMAND:
Type 147 ID=501460
SEND ERROR !!!!
Template ID number expected

changing protocol to CAN v1 in Haltech ECU manager does not make any difference.

 

Sounds like a problem you may need to call or contact racepak with on their forum.

Is this a specific dash for the haltech ECU? Or the generic logger dash?

 

Its haltech logger dash, got it working somehow - atleast showing some of the values i needed, not tried all yet... looks like Haltech instructions are out of date.....