O.K. so I finally sorted out my ignition problem and attempted to start , the car kind of starts and runs for about a second and then quits , the maps that I am using are from a stock ported motor .Does anyone have maps for a bridge (half) ported motor (the primaries are street ported out to the max. limit ) ? , I would really appreciate some help from you guys , thanks.

 

its not your maps i don't think. what ecu are you running ? if its an E6K make sure you have the ignition settings correct for YOUR setup!

 

Stock ported engines run significantly more vacuum, and therefore idle "lower" down on the map range (i.e. left side).&nbsp The bridge port would run a bit higher up the map right (i.e. more right) and needs more fuel to idle more stable.

You might want to toggle the zero throttle maps and try to adjust from there.&nbsp The zero throttle maps are easier to adjust, and easier to use with engines like a bridge port.


-Ted

 

Thanks I will try that , any one else ?.