How can i check if i have signal on Ignition Trigger - Lead (IGN-OUT)?
can't get the Lead Coil to fire
i have a haltech e6x,

 

Well, was it working before? how is the ignition setup? do you have stock distributor, do you have a 12A or a 13B? Are you using a base map from anybody?

Please give background on this installation.

 

i had ign on lead yes, i have ign fro a turbo || cas/coils on a 12A turbo, i had ign, but i tryed to connect the Black wire from lead coil, to ground (stupid me) now i thik maby i the ignitor in the lead coil is blown? but i wanna chek the signal from the haltech? to be sure

 

Well you can do that, scope the signal from the haltech, if its working you will see a signal on the scope. If you dont get a signal coming out of it, then the Haltech will need to be shipped for repairs, if it is working, then change your coils. The easiest thing to do is just swap the coil/igniter and see if fires.

 

Crank the engine over or just spin the CAS while connected.
If you see RPM's changing, then the ignition input is good.


-Ted