Hi guys! It time for me to start running those haltech wires into my engine bay. I searched on this forum before I made this post but I couldnt find one single tread or website that explains into details how to do it. I found some partial questions and answers but thats it. If anyone of you know something that would get me started I would be thankful.

 

Depends where you are mounting the ecu. I usually just use the stock harness location behind the abs pump to run the wires into the engine bay.

 

Yes, Thats when I'm going to instal mine... There were only 2 plugs going into the ESC that are coming from engine bay, but there are 2 more going to the dash... How do I hook these up?

 

You're kidding right?

https://www.rx7club.com/forum/forumdisplay.php?f=62

http://www.hitman.hm

http://www.fd3s.net/haltech_install.html

http://www.k2rd.com/haltech

Shall i keep going?

"Give a man a fish, he eats for a day... Teach a man to fish, he eats for a lifetime..."

If you need a reputable shop to take your car to for the install and tuning let me know i can also point you in that direction.

 

He couldn`t have been looking, i installed my E8 over the weekend. I do have a few questions i`ll be asking in another thread, i`ll start this coming weekend.

 

good point... I started the installation. Its time consuming. I installed the E8 at the stock location. No prob there, it was easy. Now Im putting old wiring apart ... its a mess...
I have single turbo ... do you have the same?

 

Which rotor is 1st and which is 2nd... Is 1st one in the back or one in the front of the car... THX

 

1st Rotor is in the front, 2nd rotor is in the back (closer to transmission)