Haltech Engine Configuration
 

Hi all,
I am setting up my first Haltech (Elite 2500 on NSP), and am trying my best to get familiar with the inner workings.
I'm sure I will have countless questions over the next bit, but a big one that stood out initially was the "Engine Configuration - Engine geometry" section. Its probably something simple I am not grasping, but why is TDC angle of rotor 2 set at 90* and not 180*?

Thanks,
Alex

https://cimg0.ibsrv.net/gimg/www.rx7...f39753d259.jpg

Okay so I think I'm probably just an idiot, haha. I am going to guess that setting only applies when the "odd fire" button is enabled, and it likely functions correctly @ 180* with the box unchecked?

Ah, lovely greyed out settings...

I would for sure check out the HP Academy videos and take a look at the Haltech base map to start.

Thanks! I do have some tuning experience but this is my first Haltech. Have been reading up on NSP for a year or so, have read every thread here, watched all the free tuning vids I can find, and am now considering spending some cash at HPA, Evans, or maybe EFI101.

The biggest problem I am facing currently is that I get hung up on little things that don't make sense to me. That image is actually a screen capture from a 13B basemap, I'm just super OCD and like to know how things work intrinsically before I feel comfortable adjusting anything.

Perhaps it is common knowledge, but I was assuming the greyed out value was active but non-adjustable.
I think in this case it must be an unused value, but in my opinion it should be completely blank or it should be the correct value greyed out. Seems a bit confusing for a newbie.

Alex

Correct