e6k harness wired up for t2 with allll sensor
 

fully wired e6k harness for a t2 its complete with alllllll sensors minus the ecu itself asking $275 shipped let me know thanks pm me with alll questions i also have a 13bre motor, i'm takin a different approach on my project car..the motor is a low mileage jdm and right now the manifolds are off because i was planning on getting the motor rebuilt and ported..well anyways let me know but please PM me because im honestly not going to come looking for this thread..asking $1200 obo..

What sensors does it come with? What bar MAP sensor? A big ask I know, but would your ship to Australia?

Thanks,

Chris.

will this harness mate up to the E6X?

There are subtle differences between them, so i would not recommend you try it unless you know EXACTLY! what you're doing and what to look for.

http://www.tuningtechnology.com/imag...Comparison.JPG

Here you can see the differences, mainly in the trigger wire bundle. As you can see pin 7 on the X is a main power wire, and on the K its the main trigger ground. Also, home trigger ground, pin 12 on the X is Ign4 and on the K its the home trigger ground.

What does this mean? that when using a K harness for a X you can only use it as a hall effect connection, and only connect the main trigger and the home trigger wires ONLY.

But, finally, what i would do is just buy the proper system with the proper harness, since they arent that expensive.... :D

does it matter if its s4 or s5?

Claudio thanks i will do that.

is this still for sale?