starter spins but wont crank
so since my ignition switxh is fucked up. i wired a wire to go from the starter motor to my positive terminal but for some reason when i make contact the starter just spins and it wont crank the engine. if you can help asap it would be great cause im tired of push starting this car
|
Tap the starter case with a hammer then try it. If it works, you can keep doing it for a while, but you will gave to buy a new or used starter.
If you've been doing burnouts or are bad at driving stick shift you could have overheated the flywheel and broken the ring gear loose. You can pop the plug on the bottom of the trans and look in with a flashlight to see if the ring gear is broken off or not. You can also tell by pulling the starter. |
the cog on the starter motor should fly out & extend to meet the flywheel when cranking.
sounds like its not extending..take it out of the car and run it off a battery to check. |
If you need a fd starter. I have one
|
Originally Posted by Molotovman
(Post 11667874)
Tap the starter case with a hammer then try it. If it works, you can keep doing it for a while, but you will gave to buy a new or used starter. If you've been doing burnouts or are bad at driving stick shift you could have overheated the flywheel and broken the ring gear loose. You can pop the plug on the bottom of the trans and look in with a flashlight to see if the ring gear is broken off or not. You can also tell by pulling the starter.
|
Originally Posted by Nassin31spr
(Post 11667935)
If you need a fd starter. I have one
|
All times are GMT -5. The time now is 12:11 PM. |
© 2024 MH Sub I, LLC dba Internet Brands