ok, dont know if this is the right place to ask this, but have a look at these photos:

http://img151.imageshack.us/slideshow/w ... p0035h.jpg

http://img151.imageshack.us/i/imgp0035h.jpg/

http://img87.imageshack.us/i/imgp0041j.jpg/


how would you tackle this rust problem?

regards

David Robertson

Japan 899-4332 kagoshima ken
kirishima shi kokubu chuou 1 choume
12-11-1

gmail: dr50376272@gmail.com

 

1st link is broken.

2nd picture looks like surface rust to me, nothing major.

3rd picture, I would use JB Weld as a body filler and possibly even use a flexible mesh fabric over the bigger holes to give the putty something to adhere to in the centers.

This is nothing major really, on my REPU I just did this method to fill in a 4" x 6" hole in the cab exterior.

 

check the vent area towards the top of the firewall under the dash. i had one that was rusted thru pretty bad from crap in the cowl allowing water to stand in it. actually u can remove the cowl and wipers and shine a flashlight toward the fender ends inside. if it's badly rusty u'll see it.