General Rotary Tech Support Use this forum for tech questions not specific to a certain model year
Sponsored by:
Sponsored by: CARiD

running problems

Thread Tools
 
Search this Thread
 
Old May 21, 2008 | 04:24 PM
  #1  
FCED89's Avatar
Thread Starter
Junior Member
 
Joined: Aug 2007
Posts: 20
Likes: 0
From: Cheney
running problems

i have a 86 that i put a new motor in cuz the last one blew a apex.i got it all back together it starts but wont run good acts like the rear injecters are not working right. ne ideas?
Reply
Old Jun 2, 2008 | 09:35 AM
  #2  
Whizbang's Avatar
Respecognize!
Tenured Member 20 Years
 
Joined: Sep 2004
Posts: 4,106
Likes: 72
From: Anchor Bay, CA
1. check compression of this engine. You can simply remove the bottom spark plugs, pull the 30 and 40 amp fuses for spark and fuel then have someone crank the engine and just listen. Should have three even, strong puffs per rotor. If compression seems good, proceed to 2.

2. Check the injectors. Try replacing them with known working units.

anymore information you can add would be great.
Reply
Old Jun 2, 2008 | 09:02 PM
  #3  
FCED89's Avatar
Thread Starter
Junior Member
 
Joined: Aug 2007
Posts: 20
Likes: 0
From: Cheney
oh it does...the motor ran great in the car i pulled it from

it will start up if u dump gas in the intake but the tac doesnt move when it revs up for the sec it runs on the gas dumped in
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Queppa
New Member RX-7 Technical
11
Nov 18, 2024 03:47 AM
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
sherff
Adaptronic Engine Mgmt - AUS
9
Feb 24, 2019 12:09 PM
Rotospectre
New Member RX-7 Technical
3
Mar 28, 2018 03:33 PM
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM




All times are GMT -5. The time now is 01:12 AM.