I purchased a manual transmission engine harness to convert my automatic transmission rx7 to a manual. After rebuilding the engine and connecting all the connectors to the harness under the dash(passenger side) i was left with these non compatible connectors. What's the best way to proceed from here?

I need the connector name and pin read out. This connector doesnt connect to manual transmission engine harness.

Need connector name and pin read out. This connector is not compatible with the manual transmission engine harness.

Need the names of the 2 unplugged white connectors and pin read out. Unsure what series harness this is from. These 2 connectors are none compatible with the harness that comes from the dash.

 

Theres a whole thread that documents what to do in this situation. It should be in the 3rd gen FAQ