ecentric pully setup
I received a engine without the ecentric pullys and need to determine where the timing marks go in relation to the eccentric shaft. Then install the distributor. Thanks
|
is the keywayed pulley on the engine
|
yes the keyway pulley is on the engine and I have tried all four positions on the belt pulley reseting the distributator each time but the engine hasn't fired. Suggestions?
|
The main shaft pulley can only be mounted one way because the holes are not in a square pattern. The 4th bolt will not go in any other way.
I first set the shaft at TDC by spotting the apex in the exhaust port, then backing it up to the center of the housing. Then I line up the CAS mark and stab it in. Then to check it I turn the shaft to the timing mark, take off the CAS cover, and see if the star wheel lines up with the reluctance head. |
I should have done that when the reactor was off but now the engine is in the car. The 12A belt pulleys will go on in all four positions so what I need is to find TDC on the key way pulley the belt pulleys bolt to.
|
All times are GMT -5. The time now is 11:12 PM. |
© 2024 MH Sub I, LLC dba Internet Brands