draw through 12a turbo
 

hi i was thinking of turboing my 12a but with a old school touch and was just woundering roughly how mutch of a power gain i could achive by chosing this setup. any info is good info. thanks

it will provide decent power. It will make your 0-60 be around 6.5 or 7.2 versus the stock 9.9 or something pitiful. I have the set up on my car currently. I cannot figure out whats wrong with it. I cannot tune it properly and don't have the time or money to fool with it. I will sell you my turbo kit,oil lines and all just shoot me a pm if your interested.

12a draw through
 

hay mate just pm'd you bout your turbo setup. if you could post the picks no the thread that would be sweet. thanks

has any one got any info on this topic. is there anything i need to do to my weber. thanks

ok whats the max boost i could run with out killing my engine. thanks

Depends on the motor. Mileage? How was it treated for its current mileage? Compression #'s?

Personally, I wouldn't turbo a stock 12a block unless you plan on rebuilding and keeping the boost setup after you toss the seals.

fwiw/fyi a stock jdm 12A turbo (efi) runs 6psi with a 7.5:1 compression rotor, not sure off hand what carbed 12A ratio is but im sure its higher.. be careful how much air u jam into a stock engine, from what i have read people have pumped in 10psi with out instant or catastrophic failure but your results will obviously vary. probably a good idea to use premix as well

cool thanks guys. i now have a t3 as well and was woundering what would be better to use the t3 or the t25. thanks. :icon_tup:

can i use a external waste gate on a draw through setup.thanks