Safc S-afc 2 initialize/save settings?
Hi,
I have set up my Safc S-afc 2. I set the pressure senor, the throttle sensor, the low and high range and have set up the idle speed to subtract but I can't get it to save/preform. Each time I shut it down as I am told the set up says 0% correction. Will someone walk me through it? 93 rx7 |
The initialize function ereases all data. You don't have to do anything to make it save the changes you make, it does it automatically.
I did the same thing when I had an SAFC in my last car, it took me about an hour to realize that I was ereasing the data each time I hit initialize - doh! |
turn the key off, take it out the turn it back on and it should save it.
|
I do understand that part about erasing or writing over. The problem is I never see the correction being implemented after setting them. I will create a map and then save it but when I start it up or just view with the ignition on there's no correction it's still set a "0%" +/-.
If I set the correction for example, 800 rpm @ -5% and 1000 rpm @ -5% then press exit/ then initialize, then turn off the key and restart theres no correction it still is at "0%" +/- I must be missing a step. |
do not hit initialize.
|
Initialize = erase all data
|
All times are GMT -5. The time now is 04:55 PM. |
© 2024 MH Sub I, LLC dba Internet Brands