Wutlezz's FC Build Thread
 

Hey Guys I just purchased my 1990 FC GTU only draw back it does have a auto transmission so im in the works of gathering parts to do my swap i have all the parts except the pedals, slave, lines, clutch (which i found on CL for 140) need a pressure plate also the starter other than those MISC. parts i have everything else lol


so here are some piks of Roxy

http://i1175.photobucket.com/albums/...tlezz/1486.jpg

http://i1175.photobucket.com/albums/...tlezz/1485.jpg

http://i1175.photobucket.com/albums/...tlezz/1484.jpg

http://i1175.photobucket.com/albums/...tlezz/1483.jpg

http://i1175.photobucket.com/albums/...wutlezz/30.jpg

http://i1175.photobucket.com/albums/...wutlezz/29.jpg

http://i1175.photobucket.com/albums/...wutlezz/28.jpg



My 1st Rx that i owned was a 84 FB 12a motor and then i wrapped it around a tree =[ sold that and purchased a 02 mazda protege 5 had that car for about 6 years, until my urge for the rotary came back and needed to get 1 or else i wasnt gonna be happy lol so i sold my protege and the same day she was gone i picked up my FC


http://i1175.photobucket.com/albums/..._4144286_n.jpg

but stay tuned for the build guys

future mods
-front lip most likely fro the s13 pignose
-turbo 5punds only
-wheels

:nod: :) :icon_tup: :rock:

if anyone has any leads to those parts im looking for i am from the Queens NY area and willing to buy them ASAP !!! its the only thing holding me back from getting the car on the road !!!!

By saying "turbo 5 pounds only", I'm guessing you plan on doing a six port turbo instead of the traditional complete turbo engine swap?

Nice Car, I just finished my 5-speed swap down here in DC. Make sure you buy the bolts & washers for your pressure plate (not mentioned in the archived thread) & have the right matching flywheel and clutch kit set up that will match your engine and transmission. If you can get a lightweight flywheel, so you don't have to remove the flywheel nut...... this was a B%^& to get on and off with hand tools. If I had a choice to do it again I'd buy a lightweight flywheel, but i found used parts in my area that worked great.

You should have checked rotary ressurections page on ebay. He sells full 5 speed swaps for fairly cheap. In fact all of the parts he sells are cheap.

You are correct Sir, but I got my swap parts with the purchase of my car (Drive-shaft, Trans, Flywheel, pedals) I just bought what I needed (^_^)

well now guys i have another problem -_- car wont rev over 2xxx rpm!

Car doesn't rev over 2000RPM? Well, you're wotless.