Dudemaaanownsanrx7 Water Inj Pressure Sources
Has anyone experimented with pressure sources for this kit. I have a nipple on my compressor that I use to pressurize the profec B solenoid and the wastegate. If I Tee into this, I am concerned about affecting the boost control. Has anyone experimented with this? What pressure sources are you using for your wastegate/profec/water tank(I am connecting the 8lb boost switch into the tank) as well as the h2o soleniod?
I am thinking of running a pressure line from the turbo elbow into the tank and a separate pressurized manifold source to the h2o solenoid...thoughts...comments anyone? John |
Anyone...anyone.....
|
weld a fitting into the intercooler piping and use that to pressurise the tank..
|
do not touch the boost controller vacuum source or the wastegate.
just put a new nipple in the uim and take it from there. |
When I installed his kit I got the pressure source from the Greddy elbow. I drilled and tapped it for 1/8NPT and installed the quick disconnect fittings.
https://i.imgur.com/mXbawl.jpg |
...
|
A single line from the elbow seemed to work fine for this guy.....
I too would not "T" into vital parts of the system to pressurize the tank. A single clean line anywhere from the compressor to the throttle body elbow should work fine. http://www.youtube.com/watch?v=a7JNB...layer_embedded |
All times are GMT -5. The time now is 09:54 AM. |
© 2024 MH Sub I, LLC dba Internet Brands