what might be a cause???(problem)
Ok I been having that problem for past week and still didn't figure it out. I did a 5speed conv to my rex.
I installed a 96 j-spec engine and trany(that what company told me). I used auto wirring harness. I started it and it is fine at idle but when you floor it it only goes to 4000rpm and drops down and goes up again. I thought at first that it was secondary fuel injectors, replaced them and still same thing won't rev past 4000rpm. i have a pettit ecu on it. map sensor is plugged in. no more ideas. please help. Is there anyone close in chicago that can help me. (already booked at a-spec may 8) |
??????
|
unless you changed the auto wiring harness...that is your problem. As far as I know, they are slightly different.
Sean |
Sounds like some kind of Rev-limiter, but the 3rd gen doesnt have one....If its not the injectors, could it be somewith dealing with the Secondary turbo controls?
and yeah, i would think using a auto harness on a standard engine might cause problems |
Limp mode?
|
I wouldent think its in limp mode....
Unless your getting no boost at all, then i would have to agree.... <- puts his car in limp mode for any stupid shop i take it to. you said the Pressure sensor is hooked up, so that cant be it.....Ahh, we need a Rx7 god. |
All times are GMT -5. The time now is 03:30 AM. |
© 2024 MH Sub I, LLC dba Internet Brands