Testing Throttle Position Sensor
Testing Throttle Position Sensor
I'm having some idle issues and would like to test the TPS. The manual says to attach the engine signal monitor to the PCME, but the only test equipment that I have is a volt meter.
Is there any way to test the TPS without the special tools?
Is there any way to test the TPS without the special tools?
https://www.rx7club.com/showthread.php?t=170731
Doh! That's what I get for replying to another thread before this one.
Doh! That's what I get for replying to another thread before this one.
What were your idle issues ? I'm curious because I had to replace my TPS connector recently because it was old and wires were damaged and the car was not working fine. However I have replaced it and my car is still not idling right.
The idle was constantly fluctuating between 1200 and 1400 rpms. I tested the tps and it was right on. I was able to get it mostly back to normal by following the throttle adjustment process in the above thread.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
Mar 28, 2017 03:30 PM





