RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   3rd Generation Specific (1993-2002) (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/)
-   -   Stumble no start (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/stumble-no-start-721754/)

BigJim 01-16-08 01:09 PM

Stumble no start
 
So i started my car today and it was idling. A little bit of a different idle than i remember, but i havent had a chance to drive the car since the turbo swap. I shut it down after its about half way warmed up. Try to start it like 20 minutes later. Rolls over, stumbles, tries to start, fires a little then dies. I assumed i flooded it. Pull the plugs and they arent soaked. So then i turn it over with plugs out and i get big plumes of gas comming out. So i have fuel. Well i pull my egi relay turn it over, doesnt stumble or anything, just rolls over. I put it back in, try again and it fires and stumbles but just wont start up. Any ideas?

bryant 01-16-08 01:11 PM

i would say clean your sparkplugs and try the deflood process again.

or push start.

BigJim 01-16-08 01:12 PM

yea, to snowy for a push start lol, it would just slide. Ill try cleaning plugs and deflooding, but im pretty sure its not flooded. The plugs were pretty dry.

BigJim 01-16-08 02:10 PM

cleaned the plugs and she fired right up...good deal. But does anyone know what, in removing an engine and transmission, would have been unhooked that would stop my fans from kicking on?

bryant 01-16-08 02:13 PM

only thing i can think of would be the relays.

BigJim 01-16-08 02:18 PM

What about wires down by the ecu? I have 1 black plug and 2 spade connectors that i didnt find locations for, and dont know if they were hooked up


All times are GMT -5. The time now is 01:16 AM.


© 2024 MH Sub I, LLC dba Internet Brands