RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   3rd Generation Specific (1993-2002) (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/)
-   -   Sputter at idle.... (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/sputter-idle-210319/)

Lawyer 07-30-03 10:48 PM

Sputter at idle....
 
Ive been looking around the board about this topic and just wanted to get some feedback. Make sure nothing is totaly wrong.
I just bought an Rx7. Its a 94. Its a 5spd.
This is the 3rd day I have had it and I just noticed a high ruff idle and sputtering then it stalls. It rises then drops to 1k then keeps falling and stalls and sputters. Not all the time though. Thats only if I dont give it some gas. After it warms up it goes away but there is still sputtering. But it doesnt seem like it should be. I thought it might be fouled dirty spark plugs but I dont know. Not used to the rotor. Any help apprecated
Thanks.

911GT2 07-30-03 11:37 PM

Well they normally have a rough idle when they're cold, so I wouldn't worry too much about that. As far as this sputtering is concerned, does it sound like mild backfiring? Just like a pop from the exhaust?

If so, mine does the same thing, and the cat is good, muffler was just replaced, and the engine is brand new. So I'd say its normal.

Lawyer 07-31-03 12:06 AM

Thanks for reply.
It does kinda sound like a little pop. Its got straight pipe all the way down. About the stalling? Is that ok. It idles high and if I dont give it ANY gas it will drop RPMS and stall. I just hope I didnt get ripped off. 54k miles for a 94 for 18k. It is an investment. :D
Thanks for the help.

JadedX 07-31-03 04:20 AM

i dont know about the stalling???


my never stalls and you in flordia so cold would not be the answer.

try your idle screw try adjusting it also check plugs and compression

what mods do you have?

DaedelGT 07-31-03 09:49 AM

Can someone take a picture of the idle screw? I always hear descriptions but I don't think I've ever seen a pic :)

You could always try adding some grounding straps to the car. I'm in the process of doing so and I hear great things about the improved idle.

alberto_mg 07-31-03 11:00 AM

What other mods does the car have? Whenever I hear about a straight through exhaust or anything similar from someone new, I cringe.

Seriously though, if you are not that familiar with the Rotary, you might want to consider taking the car to a specialist in your area b4 you start wasting time screwing around with different adjusting points and spending money on things like ground straps etc w/o knowing what the real issue is.

It is very difficult to analyze things like what you described without seeing it.

Lawyer 07-31-03 12:19 PM

Yeh im taking it to the shop of course, just wanted to make sure nothing is totaly wrong. Well all it has is bov straight pipe and after market muff. the most is stock cept for cone filters on the turbos

Juancm5483 07-31-03 12:29 PM

I highly reccomend that you take the car to Pettit Racing.

Lawyer 07-31-03 12:54 PM

I dont even have plates on the damn thing yet and its giving me probs :P. I just wanna know if this could hurt the engine any? The rpms fluctuate from 3k to 500. thats after it warms up. But still I just took it around the neghborhood to see if it would give me bullshit. Every cold start you have to give it gas it just wont idle. Im going to take it to the shop but do you think there could be engine probs?


All times are GMT -5. The time now is 03:45 PM.


© 2024 MH Sub I, LLC dba Internet Brands