i recently done a hose job on the seq turbo and after a trial run the second turbo refused to work. i then pulled the pipes of and i found two pipes blocked and twisted because of the extream heat , and the vacume pipes are cheap too. but now i replaced them with original piping and the second turbo is still not working i also pulled the throutle out and i found a vacume pipe poped out exactly next to the map sensor won. dose anyone think it has something to do with the second turbo, i checked the actuators of the seq set up and all seems fine dose anyone have a hint on what i can do to fix it up. by the way the turbos have no lose and spin ok. help please

 

but i also have to admit that i blocked the second turbo blow of valve and the turbo had a hard time keeping up the rpm, after that i was accelarating 1st no boost then 2nd .5 bar and then 3rd only white smoke from the muffler any ideas please is it a broken turbo shaft ??????????????????????????

 

http://www.autosportracetech.com/RX-...leshooting.htm

 

mahjik saves the day..AGAIN

 

thanks fellas

 

Malta, as in the Greek Island?

 

Hi, have you solved your problem yet? We met at Hal Far last week. I have the white '97 RX7.