removing stock IC duct
Is there a way to remove the stock IC duct without cuting around the AC canister by the battery? Ideas?
Thanks,JCC |
You have to unbolt the evaporator and VERY carefully lift it out (pulling to the driver's side). This will require bending the hard A/C lines. This is certainly doable but you have to be careful not to kink or break the lines. Just move slowly and you'll be fine.
|
next time i have to take mine out im cutting the front section off of the AC condensor part of the duct. i have removed the ducting so many times that im beginning to draw weary of the lines snapping. im not throwing my AC away either and i dont need to spend money on another useless mod
kris |
i did a perma removal with some tin snips
|
I had mine cut out, its easy. basically grab a hack saw or dremel and cut it EXACTLY in half. When you put it back on, the ac canister will actually make a near perfect seal, you can put foam around the few air leaks you would have.
I have taken this thing out alot, it WELL worth it. That is one of the worst engineering crap designes I haver ever seen. |
Cut away 1/2 of it. Throw the cut off piece away, and never worry about it again. Really bad design by Mazda.
|
BTW, that part of the AC system is the receiver/dryer. The evaporator is the part under the dash :).
Dale |
All times are GMT -5. The time now is 09:58 AM. |
© 2024 MH Sub I, LLC dba Internet Brands