problems with temp and sputters
problems with temp and sputters
Some of the mods are single turbo Borg warner 262s, v-mount, greddy blowoff, emission block off, greddy compression tube, walboro 255, street port with ra classics, atkins solid corner seals, full greddy high power exhaust, 550 primaries 1200 secondaries, light weight flywheel, act clutch.
The problem i am having is the car runs rough and sputters when it gets close to 80 c when i first start it its fine and it revs fine. The engine was rebuilt by a local shop it wasn't tuned. The cars temperature climbs all the way to 100c at idle.
I changed all the sensors, coils, ran ground wires, wire harness, and even changed the power fc to a different one
The problem i am having is the car runs rough and sputters when it gets close to 80 c when i first start it its fine and it revs fine. The engine was rebuilt by a local shop it wasn't tuned. The cars temperature climbs all the way to 100c at idle.
I changed all the sensors, coils, ran ground wires, wire harness, and even changed the power fc to a different one
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM
Adaptronic Cranking fuel table messed up?
sherff
Adaptronic Engine Mgmt - AUS
5
Sep 12, 2015 12:22 PM






