RX7Club.com - Mazda RX7 Forum - Map Sensor 3-Bar problem

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)

- 3rd Generation Specific (1993-2002) (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/)

- - Map Sensor 3-Bar problem (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/map-sensor-3-bar-problem-384728/)

Ehughes

Jan 11, 2005 02:39 PM

Map Sensor 3-Bar problem

Hooked it up. Had to cut slots w/ a dremel to make the harness fit the sensor.
Went to start the car and it read 1.19 bar and would not start. I am assuming if dumped a ton of fuel with that reading.

I followed the ABC connections posted. Any suggestions?

maxcooper

Jan 11, 2005 04:57 PM

What ECU, and did you adjust it to work with the new MAP sensor? Search for details.

-Max

RXJJang

Jan 11, 2005 05:34 PM

If you run a PowerFC you must adjust the calibration settings with datalogit (under option 2: scale/offset, 41800/0). Otherwise your car will not run.

Ehughes

Jan 12, 2005 08:58 AM

I knew I needed to adjust the settings, but did not consider its effect on start up. Thanks.

All times are GMT -5. The time now is 09:26 AM.