and it didn't work i did the switch idea that gfelber
has on his site. my sequential runs great, but when i flip the switch to go non-seq i get no boost at all i tried everything...like switching the switch and not changing the PFC to non-seq setup...and even changing it to seq setup. it just gets no boost. i am pretty sure i hooked everything thing up right, but i noticed that gfelber mixed up some wire colors on his ecu diagram. i am going to PM him about this to see if maybe that is it. i will keep you all informed. did anybody else try this and get it to work? ohhhhhhhh and i also just put in my midpipe! i love it, it stinks really bad, it is louder than crap, and blows fire...but i wouldn't trade if for the world!!!

 

I was going to do the same mod a little while back... But I never got the time... Hopefully this week. Keep us (or me, at least) informed!

 

I did it this past weekend, it works pretty good, I dont get full boost until around 4500rpm though. I ran my buddy that has a 2nd gen v8 rx7, and I pulled on him a little better in non sequential mode. I still only run about 10 lbs of boost though.

 

hey mikey did u change your maps on the
pfc

 

i did it and it worked pretty well, yes, the wires on his diagram are not at the good place, check with the electrical diagram in the shop manual.

puma

 

Puma,

What does "not at the good place" mean? I'm pretty sure I checked and re-checked the wire colors.

Gene
www.purplemantis.com

 

yep the color is right, just not well located on the ecu diagram.