Jacking Points?
 

Folks,

What jacking point do you guys use for front and rear?

https://www.rx7club.com/3rd-generati...cation-722987/
https://www.rx7club.com/3rd-generati...ispreloading=1

Lots of threads on this topic, but might as well make something useful out of this one…I use a Quickjacks 5000. It’s kind of like a cross between jack stands and a lift. It jacks up the car from the factory pinch weld jack points and is super quick and easy to use. Like any other tool like this you need to be careful and make sure you lock it otherwise you could be crushed under the car. I usually slide jack stands under the subframes for added safety.

I refuse to use the pinch welds with a floor jack or jack stands, as they crush too easily.

In one of the previous threads, a lot of people mentioned jacking up the front via the front subframe, and the rear via the diff. I use those locations and they seem to work fine. For the jack stands, I put them on the front chassis legs (with rags as padding) and on rear subframe where the lower control arms connect.

Yea, you should never have to actually put weight on the pinch welds themselves. There are rubber pads for jacks/jack stands that have a little slit in them, so the weight of the chassis rests directly on the pads. The aforementioned Quickjack system includes large rubber pads like this. Pinch welds on my FD look like they are brand new. I agree with not jacking the car up on the pinch welds with a floor jack when there are better places to do it

Thanks, I've never thought to use rubber pads on jack stands. My car's pinch welds have definitely seen better days.

You just turn the jack stand sideways and put it just to the inside of the punch weld.

​​​​
This is the way: https://www.flyinmiata.com/NA/fm-jack-adapter.html

I always jack up my car by the front subframe middle then put jack stands on the pinch welds with the rubber pinch weld adapters. Then jack the rear from the diff and put the floor jacks in the same place.

If you don't have the adapters put the jack stands on the subframe. There are good spots on the subframe a floor jack works at and it's much thicker steel.

Dale

Pinch welds aren’t visible unless you on you’re hands and knees and unlike subframes they are capable of supporting the car with far less risk of slipping. Mine will scratch the undercoating on occasion but they’ve never crushed. Not certain what a chassis leg is, but pinch welds are also the factory suggested jacking point.
Jacking the car up by the rear differential or front subframe may not always be avoidable, but if not using a lift I like to run the front of the car up on ramps so I can clearly see to position the Jack on the front subframe and avoid the pan.
If you’re concerned about scratching a pinch weld I’d suggest getting some inexpensive jack stand pads from Harbor Freight to support the car once up.
Most people don’t realize that eyes really can bug-out like a cartoon character from the weight of a vehicle.