3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

ignition problem??

Thread Tools
 
Search this Thread
 
Old Jun 13, 2004 | 12:31 PM
  #1  
USCmatt's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Feb 2002
Posts: 448
Likes: 1
From: S.Carolina
ignition problem??

Ok, new problem now. I was driving with a friend to get some lunch about a week ago, and when i got back in the car to get on the interstate, it didnt want to rev above about 2000-2500 rpms (AT by the way). Also, if I tried to accelerate anything more than a feather touch on the gas, it would do nothing at all. I could I actually made it up to about 60 miles an hour, but it took me about two minutes to get there. However when I hit an uphill, it would only want to go about 30-45mph. So basically.....only very slight acceleration, and wont go above 2500 rpms.

I took the car into the mazda dealer in rock hill, sc. They had the car for a week, replaced the spark plugs and fuel filter. After that, the car ran like it was supposed to, that was on friday. Saturday morning I drove the car columbia, and then to kershaw to a classic car/corvette car show. I got back in the car after the car show, and wham, same problem again. I limped the car down the country roads back to columbia only being able to go about 45-50.

Other notes: Chassis - 103,000 , Engine - 25,000 (compression was standard) , tranny - 10,000.
Reply
Old Jun 13, 2004 | 03:48 PM
  #2  
USCmatt's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Feb 2002
Posts: 448
Likes: 1
From: S.Carolina
any comments?? I thought at first it might have been a clogged cat, and the dealer checked to see if it was. He told me that everything seemed fine with the exhaust though. However, it seems odd that with 103,000 miles on a stock exhaust everything probably isnt just peachy with it.

I left it sitting at a friends house all of last night, and I just went out and started it about 15 minutes ago. It did the 3,000rpm warm up just fine. It revs in park and neutral without issues. It's just that when I put it in drive and actually try and move that car that it has this severe acceleration problem.
Reply
Old Jun 13, 2004 | 04:17 PM
  #3  
cewrx7r1's Avatar
Eye In The Sky
Tenured Member: 25 Years
iTrader: (2)
 
Joined: Feb 2001
Posts: 7,941
Likes: 132
From: In A Disfunctional World
Maybe you have trash in the tank. And it took this long to again clogg up the filter. Check this out.

Or maybe your pump is going dead. Run the fuel pressure test as per the manual.
Reply
Old Jun 13, 2004 | 04:25 PM
  #4  
cruiser's Avatar
Rotary Freak
Tenured Member 05 Years
 
Joined: Dec 2002
Posts: 2,522
Likes: 0
From: Slovenia, Europe
Check MAP sensor
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ncds_fc
2nd Generation Specific (1986-1992)
19
Sep 15, 2015 12:03 AM
meetRoX7e
General Rotary Tech Support
4
Sep 11, 2015 11:09 AM
SakeBomb Garage
Vendor Classifieds
1
Sep 7, 2015 03:44 PM
SakeBomb Garage
SakeBomb Garage
1
Sep 7, 2015 03:32 PM




All times are GMT -5. The time now is 01:40 AM.