How do I calibrate my Tach + clean it
Hi,
I just finished doing the Linearization of my temp guage and resoldering of the joints on my tach. Got a little prob :( 1. How do I recalibrate my tacho? It is reading about 1k too high. I read on another thread that I should remove the bottom stop needle and push the needle anticlockwise to about -1500 but is there an accurate way to do this? Or is that the "Approved way" :) 2. I got a little oil/grease mark on the dial. What can I clean this off with? (It's just natural hand moisture/oil, not Castrol or anything like that) BTW, the Linearization procedure is great. It's nearly as good as a adding an aftermarket water temp guage, without losing the space. Thanks Trevor |
I don't know how to calibrate but I can help with the other part of this thread.
Get some rubbing alcohol to clean it. Use cu-tips on the hard to get to spots. |
All times are GMT -5. The time now is 01:40 PM. |
© 2024 MH Sub I, LLC dba Internet Brands