Secondary injectors are stuck open when I put the car on acces.. ????

Here is the story

I have been doing the don't be a rikki non-seq setup along with putting in my power fc...

After the non-seq setup was done and I triple checked everything to make I didn't screw anything up or forget something stupid soooo I then proceeded to install my PFC which took no time at all.. So now that the PFC is in.... I start the "before starting your car procedure" I turn the car on acces right away I start to smell gas real bad so I knew something was wrong so I started to go over everything again....I then took off my IC & all piping my IC was full of gas and the air filters were leaking gas... I cleaned up the mess tore off the UIM, LIM, turbos etc.. Then I started trying to findout where the hell the fuel came from? I turn the ign onto acces again and viola the 2ndary injectors are spraying like a mother...why is this??


so now the motor is extremely flooded... how do I go about unflooding the motor?

 

1) You'll probably need to have the injectors cleaned.

2) Search for "unflood procedure"

 

Well i have a fuel system on the way.. i was just making sure that it wasnt anything i overlooked or anything that could be wrong with the pfc..

Thanks for any info..

 

no one else has any idea?