Hardlining a GT35r
 

I've got a fully functioning 35r setup on an ASE manifold that I'd like to hardline the water lines on (mostly for aesthetic reasons if I'm honest!)
However, I'm having a nightmare finding the bits to do it. I want to run a 3/8 hardline (with an expansion loop) but I want to connect it to the turbo core with a banjo fitting to make install/removal and routing easier. The only option I seem to be able to find is a banjo to AN6, then connect to the hardline with a tube nut, which is fine, but I can only find them in anodised aluminium, which I'm not keen on. I ideally want stainless, but decent quality steel fittings would be fine.

Has anyone else done similar? And if so, what did you use?
Cheers
Si

Have a look through British American Transfer website:
http://www.batinc.net/mocal.htm

They have the steel fittings you are looking for, and also some steel banjos. You must call and place your order over the phone. So you need to get a whole list of all the part numbers you need from the catalogs. They have very good feedback here on the forum.

Whats wrong with aluminum? Are you looking for stainless banjos and tube nuts or just the tube nuts?