RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   3rd Generation Specific (1993-2002) (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/)
-   -   Efini Y pipe Part nummer and info request (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/efini-y-pipe-part-nummer-info-request-664571/)

Speedworks 06-22-07 05:25 AM

Efini Y pipe Part nummer and info request
 
I'm looking for the PN of the OEM alloy bridge tube from the Y pipe to intercooler section.

It's for replacement of the plastic one.

Was the lower Y-pipe section changed/updated over the years? Is there any gain in replacing the lower and upper Y pipe as one piece or is it enough to replace the upper one for cracking insurance?

Just asking.

Neal

Phread 06-22-07 08:00 AM

try here.....$249 (link below)
most have changed to the Efini part when the haye problems or just upgrade their system....I've been told that it flows better than stock.
I would change both to get the plastic out.....IMHO.

http://rx7.com/store/rx7/fdintercooler.html#efinipipe

killswitch 06-22-07 08:09 AM

You need the crossover pipe and the part it attaches to as it's now as gasket that sits between them with two bolts on it so you can't use your original one. The half of the y-pipe with the actuator on it the same as the stock earlier ones but the other half is different.

theorie 06-22-07 10:33 AM

you need both parts. (the y pipe and the crossover pipe) they are sold as a kit. here are pics from my install:

before - old setup:
http://memimage.cardomain.net/member...29_17_full.jpg

old Y pipe installed:
http://memimage.cardomain.net/member...29_18_full.jpg

old vs. new:
http://memimage.cardomain.net/member...29_20_full.jpg

old vs. new again:
http://memimage.cardomain.net/member...29_21_full.jpg

new installed:
http://memimage.cardomain.net/member...29_22_full.jpg

install complete:
http://memimage.cardomain.net/member...29_23_full.jpg

Speedworks 06-23-07 06:18 AM

Ok I get the point.


Theorie, do you happen to know the PN's of both parts.

Are you by any chance Tom? If so, I had you on MSn for quite some time untill you sold the grey FD

Neal

Sgtblue 06-23-07 09:02 AM


Originally Posted by Speedworks (Post 7068097)
Is there any gain in replacing the lower and upper Y pipe ........?
Neal

While a major advantage to the Efini kit is the elimination of the soft coupler, the design of the 'Y' pipe itself is slightly different to allow better flow. You can see the difference in the 3rd pic posted by Theorie, particularly around the BOV hose connection. Exactly how much improvement is debatable, but it's still an improvement.

theorie 06-23-07 10:22 AM


Originally Posted by Speedworks (Post 7071580)
Ok I get the point.


Theorie, do you happen to know the PN's of both parts.

Are you by any chance Tom? If so, I had you on MSn for quite some time untill you sold the grey FD

Neal

yep thats me. hey neal, i remember you! i have a new msn name. it's in my rx7club profile i think


All times are GMT -5. The time now is 07:02 AM.


© 2024 MH Sub I, LLC dba Internet Brands