RX7Club.com - Mazda RX7 Forum - Did i forget anything?

K..this is the stuff ive done to my car so far...can you think of anything (performance wise) that i should do to my car? i was thinking about water injection but that about it as far as i can see, but i know im forgetting something so maybe you guys can help me out. OH! just thought of antother one...sway bars...need those can any of you give me advise on those?and maybe CF or aluminum driveshaft? all help is appreciated. thanks -sky

94 touring(everything but the engine has only the dyno miles from tuning on them)

engine:
RP 3mm apex seals large street port w/19k miles (compression test before turboes were added showed 8.9s across the board)
all emissions removed/blockoff plates installed
ported throttlebody

Turboes:
Efini twins(sequential)
all new silicone hose job (simplified)

Tuning:
PFC w/commander
338 whp @ 13.2psi(.9 bar) on 91 octane pump gas and conservative tuning.

Fuel System:
Stock rebuilt 550cc primaries
new primary fuel rail w/new pulsation dampener
kg parts secondary fuel rail
bosche 1600cc secondary injectors
SX FPR
SS fuel lines
Walbro fuel pump(may want to get better pump)

Cooling:
Fluidyne racing radiator
Aluminum AST
Greddy large SMIC
Trust airynix cold air intake
all aluminum piping for turboes and intercooler including greddy elbow

Exhaust:
3" petit racing down pipe
3" pettit mid pipe
Apexi N1 single tip 3"

Suspension:
Tanabe Sustec Pro SS coilovers
RP trailing arms and toe links
RP chromaly racing axles
Ebay front and rear strut bars

Drivetrain:
RP short shifter
4.30 rear end
Kaaz racing LSD
RP solid diff mounts
Bonez street comp clutch
streetlite 11lb flywheel
ss clutch line
greddy pully kit

Brakes:
Bonez Crossdrilled rotors front and back
Bonez stage 1 competition brake pads
SS break lines

Shoes:
CCW SP20 18X10 all around (7.4" backspacing!)
Kumho ECSTA V700 285/30-18 all around

inside/look good stuff:
greddy turbo timer

R1 front lip(99 spec front end coming)