RX7Club.com - Mazda RX7 Forum - Is this the correct position of the pre-spool for non seq?

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)

- 3rd Generation Specific (1993-2002) (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/)

- - Is this the correct position of the pre-spool for non seq? (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/correct-position-pre-spool-non-seq-411931/)

Fatman0203

04-05-05 05:34 PM

Is this the correct position of the pre-spool for non seq?

Or did I weld it the wrong way? BTW is the wastegate there closed or open?
Thanks!

http://img.photobucket.com/albums/v6...203/wheels.jpg

Fatman0203

04-05-05 06:44 PM

Bump ^

RX7WEEE

04-05-05 06:46 PM

Yeah, I'm 90% sure you got it correct.

jimlab

04-05-05 08:09 PM

This picture shows the correct location of the pre-control gate... gone. :)

http://www.micromanx.com/goble/rx7/p...turboparts.jpg

Fatman0203

04-05-05 08:24 PM

Quote:

Originally Posted by jimlab

This picture shows the correct location of the pre-control gate... gone. :)

I knew someone would mention that, I got everything fixed and its running quite nice.
Thanks guys.

CourageOO7

04-05-05 09:01 PM

well, tie it off that way...if you only get 7psi of boost you got it wrong! :O) IF I remember correctly, the end of the hinge should be closer to the rear of the car...think that's the way you have it.

CourageOO7

04-05-05 09:02 PM

Good!

All times are GMT -5. The time now is 05:19 PM.