bad clutch cylinder?
 

sometimes when I hold my clutch in it will lose pressure and stiffnes and stay pressed in when I take my foot off but then if I pop the pedal out with my foot it will be stiff again. Clutch was replaced about 1500 miles ago so I dont think its any of the bearings or anything with that, so does it sound like I need to replace my master and slave cylinders? BTW the line has been bled a cple different times and this symptom still pops up.

Same here, I'm replacing the spring, seals and piston for the clutch cylinder tomorrow. Got the same issue as you. I ordered my set from Ray Malloy Madza part # FD01-49-460 for $19.00. Tell him you're an RX-7 member, it lists for $34.96

Ray Crowe 1 888 533 3400

My master cyclinder was replaced by previous owner. I think I'll bleed the entire brake system at the same time. Replace it with synthetic fluid.

I replaced the clutch so that's not the issue, looks like both of us have the same problem. I'll repost the status and resolution when it gets done.

Thanks for all the info man, I appreciate it. Hope it fixes the problem.

no problem, any time for a FD driver! Let us know if you still have problems.